Product Description

Installation and Removal

1. Comb Installation and Removal

l  For comb installation, gently push the comb into the slot until it snaps into place.

l  For comb removal, move the comb to the highest gear, hold it with one hand and gently pull it out.

Notes: This product contains 1 comb (0.5-10mm).

realme Beard Trimmer use is supported only, Sharing with other brands is not supported.

2. Blade Installation and Removal

For blade installation, insert the connector A of the blade into the slot B, and press it until it snaps into place.

For blade removal, first rotate the blade to raise it and have the blade teeth face you, then put your hand on the blade as indicated in the drawing, and finally gently pull it up until it is separated from the slot.

How to Use It

1. ON/OFF

Press the On/Off button to turn on/off the trimmer.

2. Comb Length Adjustment

After the comb is turned off, adjust the comb length as needed through the knob. Each gear represents 0.5mm

3. Beard Trimming

After the comb is adjusted to the length needed, turn on the trimmer and gently move it to trim the beard.

Note：

Do not install the comb while trimming the beard. Be careful while using the trimmer in case of accidental cuts on the skin.

4. Travel Lock

l  The trimmer is designed with a travel lock to prevent the trimmer from accidentally working during transportation.

l  Enabling the Travel Lock: when the trimmer is turned off, press and hold the On/Off button for 3 seconds until the indicator turns orange and flashes thrice. The trimmer won’t be turned on accidentally and start working during transportation.

l  Disabling the Travel Lock: Press and hold the On/Off button for 3 seconds until the trimmer starts working, and then press the On/Off button again to turn off the trimmer.

Notes:

Press the On/Off button when the trimmer is locked, and the indicator will turn orange and flash thrice but the trimmer won’t start working.

Battery Level Indication

Cleaning

l  Turn off the trimmer and clean it from the top from the top with the brush.

l  Remove the blade on the side, and clean the hair compartment and blade with the brush.

l  Install the blade after cleaning, and turn on the trimmer to check whether it snaps into place.

Warning: cleaning and maintenance must be conducted after the device is powered off.

The product does not support full body washing, please do not allow water or other liquids to enter the charging port to prevent water formation if the finished product is damaged!

Product parameters